GE WR55X10020 Electronic Control Board

Description

General Electric WR55X10020 Ice Machine Control Board
(Orders Over $75 get Free S&H)

Replaces Part Numbers: 880043, AH304099, AP2071665, EAP304099, PS304099.
Non Refundable Part! Return For Warranty Replacement Only!

Installation Instructions:

• Unplug the ice maker or shut off the house circuit breaker to disconnect electrical power.
• Open the ice maker door and put a cloth to cover the drain hole in the ice storage bin.
• Remove the front door by removing the screw on the top hinge.
• Remove the upper hinge plate.
• Remove screws at four top corners.
• Raise the top at a 45 degree angle to remove the control housing cover.
• Take a digital photo of the wires connected to the control board so you can reconnect them correctly.
• Disconnect the wires from the electronic control board and remove the mounting screws that secure the control board in the housing and remove the board.
• Position the new electronic control board in the housing and secure it with the mounting screws.
• Using your digital photo as a guide, reconnect the wires on the control board and reattach the mounting screws.
• Reverse the procedure to put machine back together.
• Remove the cloth that was used to cover the drain hole in the ice storage bin.
• Once everything is together, plug the ice maker into the wall outlet or reset the house circuit breaker to restore power.
• Now would be the perfect time to run the machine thru a cleaning cycle.
• Now it?s all done and ready to start producing ice.