GE WR57x21246 Valve & Tube AP5957543

SKU: WR57x21246 Categories: ,

$24.00

In Stock

GE WR57x21246 Ice Maker Water Valve & Tube

Part Number WR57X21246 Replaces: PS10065392, AH10065392, EAP10065392, AP5957543, 4338058.
Valve Has (1/4″ Threaded Inlet) – (1/4″ Easy Slip Outlet)

Installation Instructions::

  • Pull the refrigerator away from the wall far enough so you can access the water line connection and work on the back of the refrigerator. Place a towel under the water valve assembly to catch water.
  • Unplug the refrigerator or shut off the circuit breaker for the refrigerator.
  • Turn off the water supply to the refrigerator.
  • Remove the screws that secure the service panel on the back of the refrigerator and remove the panel.
  • Remove the screw(s) that secures the mounting bracket to the frame of the refrigerator.
  • Pull water valve out of refrigerator cavity.
  • Disconnect the supply water line.
  • Disconnect wire harness at solenoid of valve.
  • Cut ice maker water tube close to outlet port where it connects to old valve.
  • Remove old water valve.
  • Now to install new valve.
  • Insert water tube as far as possible into outlet port of new ice maker water valve.
  • Tug on the water tube to make sure it’s seated properly.
  • Attach wire harness lead to the solenoid coil.
  • Insert water valve into refrigerator cavity and attach mounting bracket screw(s) to frame of refrigerator.
  • Next connect the supply water line. Tighten nut snugly.
  • Turn water on and check for leaks.
  • When all is good, attach back cover and slide refrigerator back into place.
  • Now it’s all done and ready to make some sparkling ice so you can relax and enjoy your favorite cold beverage.

You save approximately $125.00 by doing this repair yourself.

The WR57x21246 Valve & Tube Is Found For The Following Models.