Replace Whirlpool W10295370A Water FILTER 1

Locate filter compartment at the right upper corner inside the refrigerator.
You might have to remove the upper shelf for more room.
Gently lift up on filter cover and filter will automatically slide out.
Slide old filter all the way out, noticing the arrow on the end is facing up. (the water will shut off automatically)
Discard the old filter.
Line the arrow on end of the new filter upward.
Gently Push the new filter into the fridge with arrow facing up till it stops.
As you close the filter cover you will notice that the filter will go in and lock into place.
Reinstall Shelf (if taken out)
Reset your change filter light (if your fridge has one)

Locate filter at the lower front grill of refrigerator.
Gently lift up on filter cover and filter will automatically slide out.
Slide old filter all the way out, noticing the arrow on the end is facing up. (the water will shut off automatically)
Discard the old filter.
Line the arrow on end of the new filter upward & Gently Push the new filter into the fridge with arrow facing up till it stops.
As you close the filter cover you will notice that the filter will go in and lock into place.
Reset your change filter light (if your fridge has one)

Press the light switch (the one that the refrigerator door presses each time you close the door) 5 times within 10 seconds.
OR: if the refrigerator has a filter button, press and hold it for 5-10 seconds.
OR: if the refrigerator has

Press OPTIONS BUTTON, Then LOCK BUTTON, Then MEASURED FILL BUTTON.

Flush Filter with Water from Dispenser (Approximately 2 gallons) until Water Runs Clear and air is purged from system.
Write the date of installation on the filter and mark your calendar for 4 – 6 months as a reminder to Change Your Filter.

WHR1RXD1 Whirlpool W10295370a Water Filter 1