LG Refrigerator Water Filter Replacement Instructions

LG (ADQ74793501) LT1000P – LT1000PC Kenmore 46-9980 Filter

Replacement Instructions

  1. Locate Filter in a Flip Down Compartment At The Left Side Rear of Ceiling and Pinch sides of the water filter cover to open and pull downward.
  2. Rotate Water Filter Downward and turn counterclockwise to remove the water filter. NOTE: If the filter is hard to remove, turn off water supply and relieve pressure at refrigerator door water dispenser before installing new filter.
  3. Holding new filter, remove the packaging and end-cap.
  4. Insert the new water filter into the filter head and turn it clockwise until it clicks in place.
  5. Rotate the water filter up into position and close the cover until it snaps shut.
  6. Run water from the dispenser for 5 minutes (about 2½ gallons) to clear the system and prevent sputtering.
  7. Reset your indicator light (if your fridge has one).

Resetting Your Filter Change Indicator

  1. Hold down the LIGHT/FILTER button for 3 seconds.

Maintenance For Refrigerator Water Filtration System

  1. Flush Filter with Water from Dispenser (Approximately 2 gallons) until Water Runs Clear and air is purged from system.
  2. Write the date of installation on the filter and mark your calendar for 4 – 6 months as a reminder to Change Your Filter.

LG LT700P ADQ36006101 Kenmore 46-9690 Water Filter

Replacement Instructions

  1. Locate Filter and Push button to open filter cover.
  2. Pull cartridge down & Pull out the filter. NOTE: If the filter is hard to remove, turn off water supply and relieve pressure at refrigerator door water dispenser before installing new filter.
  3. Holding new filter, remove the packaging and end-cap.
  4. Insert the new filter into the manifold hole until it stops.
  5. Push the cover back up until it clicks into place.
  6. Run water from the dispenser for 5 minutes (about 2½ gallons) to clear the system and prevent sputtering.
  7. Reset your indicator light (if your fridge has one).

Resetting Your Filter Change Indicator

  1. Hold down the LIGHT/FILTER button for 3 seconds.

Maintenance For Refrigerator Water Filtration System

  1. Flush Filter with Water from Dispenser (Approximately 2 gallons) until Water Runs Clear and air is purged from system.
  2. Write the date of installation on the filter and mark your calendar for 4 – 6 months as a reminder to Change Your Filter.

LG LT500P 5231JA2002A Kenmore 46-9890 Water Filter

Replacement Instructions:

  1. Locate the existing filter. It will be located behind the light cover above the top shelf on the right hand side.
  2. Remove the top shelf. This will give you more room to remove and install the new filter.
  3. Remove the light cover by pressing the release clip on the bottom of the cover and pulling the cover out and up to remove the light cover.
  4. Locate existing filter and remove it by turning it counter clockwise.
  5. Holding new filter in your hands, carefully remove the packaging and sanitary end-cap from the new filter.
  6. Check the black o-rings making sure they are both on and not damaged (torn or cracked).
  7. Locate the Start arrow found at the top of the instruction label on the back side of the filter and Align the Start arrow with the arrow on the refrigerator filter head.
  8. Apply slight upward pressure and rotate the filter clockwise until the Stop arrow on the front of the filter label is aligned with the arrow on the refrigerator filter head.
  9. Ensure filter is fully installed in the refrigerator filter head a full 1/4 turn. This is required to activate the internal valve inside the refrigerator.
  10. If the filter is not turned 1/4 turn the valve will not fully open and may cause the water flow to be slow, or even cause the valve to make a chattering noise during use.
  11. Dispense water for approx. 2 gallons making sure that air and water is completely flushed from the system.
  12. Replace the light cover and top shelf.
  13. Locate and follow instructions on use of date label for your filter.

Resetting Your Filter Change Indicator

  1. Hold down the LIGHT/FILTER button for 3 seconds.

Maintenance For Refrigerator Water Filtration System

  1. Flush Filter with Water from Dispenser (Approximately 2 gallons) until Water Runs Clear and air is purged from system.
  2. Write the date of installation on the filter and mark your calendar for 4 – 6 months as a reminder to Change Your Filter.

LG LT600P 5231JA2006 Kenmore 46-9990 Water Filter

Replacement Instructions:

  1. Locate existing filter and remove it by turning it counter clockwise. The filter will eject slightly with a clicking sound.
  2. Holding new filter in your hands, carefully remove the packaging and sanitary end-cap from the new filter.
  3. Insert the new filter into the refrigerator filter receptacle. With the handle in the vertical position, push the new filter into the housing until it stops. When inserting the new filter, twist the handle slightly left to right, while pushing inward.
  4. Rotate the filter clockwise a full 1/4 turn until you feel it stop. Ensure filter is fully installed in refrigerator head a full 1/4 turn. This is required to activate the internal valve inside the refrigerator.
  5. If the filter is not turned a full 1/4 turn the valve will not fully open and may cause the water flow to be slow, or even cause the valve to make a chattering noise during use.
  6. Run water from the dispenser for 5 minutes – (about 2½ gallons) to clear the system and prevent sputtering.
  7. Reset your ‘change filter’ light (if your fridge has one).

Resetting Your Filter Change Indicator

  1. Hold down the LIGHT/FILTER button for 3 seconds.

Maintenance For Refrigerator Water Filtration System

  1. Flush Filter with Water from Dispenser (Approximately 2 gallons) until Water Runs Clear and air is purged from system.
  2. Write the date of installation on the filter and mark your calendar for 4 – 6 months as a reminder to Change Your Filter.

LG LT800P ADQ73613401 Kenmore 46-9490 Water Filter

Replacement Instructions (CEILING MOUNT)

  1. Locate Filter in a Flip Down Compartment At The Left Side Rear of Ceiling and Pinch sides of the water filter cover to open and pull downward.
  2. Rotate Water Filter Downward and turn counterclockwise to remove the water filter. NOTE: If the filter is hard to remove, turn off water supply and relieve pressure at refrigerator door water dispenser before installing new filter.
  3. Holding new filter, remove the packaging and end-cap.
  4. Insert the new water filter into the filter head and turn it clockwise until it clicks in place.
  5. Rotate the water filter up into position and close the cover until it snaps shut.
  6. Run water from the dispenser for 5 minutes (about 2.5 gallons) to clear the system and prevent sputtering.
  7. Reset your indicator light (if your fridge has one).

Resetting Your Filter Change Indicator

  1. Hold down the LIGHT/FILTER button for 3 seconds.

Maintenance For Refrigerator Water Filtration System

  1. Flush Filter with Water from Dispenser (Approximately 2 gallons) until Water Runs Clear and air is purged from system.
  2. Write the date of installation on the filter and mark your calendar for 4 – 6 months as a reminder to Change Your Filter.